DIESEL TRUCK RULES

Attention Pullers:  Upon you registering & paying your hook fee, you are in agreement that you have read and understood the rules for the class that you entering and the general rules, and that it is your understanding that your truck/tractor meets these rules.

If your truck\tractor fails to pass these rules, there will be no refunds given. So if you have any questions about the rules make sure, you ask a tech official before registering. .

 

8500 LB STREET DIESEL TRUCK

1. Must be licensed, registered, and insured (Bring CURRENT registration and insurance with you to register)

 

2. Single Turbo charger only. Must bolt directly to manifold , NO adapter plates. The compressor housing may be no

larger than a 2.4 inch ROUND inlet measured at the smallest diameter area of the compressor wheel. Downsizing of

the compressor housing ahead of the wheel is NOT allowed but must meet the 2.4 inch diameter for at least 3/4 inch in front of the wheel along the bore. The inlet will be measured using a 2.45 inch plug. A stock MWE groove is allowed.  No MWE groove will be allowed that has greater than a 1/4 inch width. All provisions allowing air to the wheel other than the bore and the MWE groove are prohibited.

 

3. All Computer chips and boxes are permitted

 

4. Stock appearing injection pump LIMITED TO ONE .

 

5. No Nitrous, Propane or Water Injection- All Bottles Must Be Removed

(a) Pullers will declare upon being teched if their truck has any equipment capable of delivering NITROUS

OXIDE and\or PROPANE.

(b) Upon the pullers declaration of having this equipment the PULLER will make the bottle end of the line

to the delivery solenoid available to the techs for a visible inspection, to insure that it is not capable at the

time of pulling to deliver NITROUS OXIDE or PROPANE

© Upon inspection of the truck and the above mentioned equipment is found , and the PULLER failed to

declare his TRUCK possessed this equipment, the PULLER and TRUCK will be immediately disqualified ,

not allowed to pull and will forfeit all entry fees paid.

 

6. There will be under hood inspections

 

7. Original style front and rear suspension. Lowering or raising vehicle height with suspension modifications is permitted.  No Strapping or Chaining of Front or Rear Suspension. CENTER LINK maybe strapped down.

 

8. Air Bags permitted, must have only 1 airline running to them and line must be capped off, no air tanks, compressors or in cab controls.

 

9. Traction Bars must have a safety loop or strap securely attached to frame & bars near where bars attach to frame of truck.

 

10. Front Hanging Weights are allowed, NOT to exceed 60 inches forward of the center of the front axle. THIS WILL BE MEASURED FROM CENTER OF FRONT WHEELS TO FURTHEST MOST POINT OF THE WEIGHTS OR

WEIGHT RACK . NO Weights in cab of truck.

 

11. Factory or commercially distributed aftermarket hitch. Must be horizontal to the ground and stationary in all

directions. Height from ground must not exceed 26 “. Minimum 3 1/2-inch diameter for sled hook. (NO UNDER

BED PULLING HITCHES)

 

12. Hook point must be past rear of truck bed.

 

13. NO hitches with chains holding it to a gooseneck ball or other device in truck bed.

 

14. Truck must have both front and rear bumper.

 

15. Driver must provide clevis, minimum 3 ½ “diameter.

 

16. No weight transfer hitches.

 

17. No chains, studs, spikes, etc.